Delphi — Measure Cylinder Liner Standout (Height Above Block)

CTM100 (06APR04) 02-030-11 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=151 Cylinder Block, Liners, Pistons, and Rods Measure Cylinder Liner Standout (Height Above Block) IMPORTANT: Remove all gasket material, rust, carbon and other foreign material from top deck of cylinder block. Use compressed –UN–03NOV97 air to remove all loose foreign material from cylinders and top deck. NOTE: Liners having obvious defects must be replaced RG6439 as a matched piston and liner set. Liner Standout 1. Bolt liners down in seven locations using cap screws and washers. (See REMOVE PISTONS AND CONNECTING RODS, earlier in this group.) Tighten cap screws to 68 N•m (50 lb-ft).

Specification Cylinder Liner Cap Screws (For Checking Liner Standout)— –UN–09DEC97 Torque............................................................................. 68 N•m (50 lb-ft) 2. Using JDG451 Gauge (B) along with D17526CI (English scale) or D17527CI (metric scale) Dial RG8330B Indicator or KJD10123 Gauge (C), measure liner height (A) for all cylinders. Measuring Liner Standout 3. Measure each liner in four places at approximately 1, A—Liner Height 5, 7, and 11 o’clock positions as viewed from rear of B—JDG451 Gauge engine (flywheel end). Record all measurements by C—KJD10123 Gauge cylinder number. NOTE:

Variations in measurement readings may occur within one cylinder and/or between adjacent cylinders. 4. If liner standout is below specification, measure liner flange thickness. (See MEASURE LINER FLANGE THICKNESS later in this group.) Measure liner counterbore depth in cylnder block. (See INSPECT AND CLEAN CYLINDER BLOCK, later in this group.) Continued on next page RG,RG34710,108 –19–13AUG99–1/2 02 030 11