Cylinder Block, Liners, Pistons, and Rods Specification Cylinder Liner Height (Standout)—Height Above Block 0.030—0.117 mm (0.0012—0.0046 in.) ................................... Maximum Permissible Height Difference at Nearest Point of Two Adjacent Liners or Within One Liner 0.05 mm (0.002 in.) .................................................................... Cylinder Liner Shims Available— Thickness 0.05 mm (0.002 in.) .................................................................... Thickness 0.10 mm (0.004 in.) .................................................................... 02 030 12 IMPORTANT: ONE LINER SHIM ONLY may be installed under any given liner flange. 5.
Add shims or replace any liner that does not meet standout specification at any location. RG,RG34710,108 –19–13AUG99–2/2 Remove Cylinder Liners Using D01062AA or D01073AA Cylinder Liner Puller 1. Remove cap screws and washers securing liners to cylinder block. 2. Number cylinder liners and mark fronts to ensure correct assembly. NOTE: Each cylinder liner must be reinstalled in same cylinder bore from which removed. Always keep matched pistons and liners together. 3. Use D01062AA or D01073AA Cylinder Liner Puller (B) with a 2.27 kg (5.0 lb) slide hammer to remove cylinder liner (A). IMPORTANT:
When using D01062AA (or D01073AA) Cylinder Liner Puller (B) to remove liner (A), be sure jaw (C) of puller is correctly positioned before attempting to remove liner. RG1179 –UN–05DEC97 DO NOT over-tighten liner puller to remove liners. Doing so could easily break liners. Removing Cylinder Liners A—Liner B—Cylinder Liner Puller C—Jaw CTM100 (06APR04) 02-030-12 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,109 –19–13AUG99–1/2 040604 PN=152