Cylinder Block, Liners, Pistons, and Rods Visually Inspect Cylinder Liners IMPORTANT: If pitting has occurred, check condition of coolant. 02 030 1. Inspect exterior length of liner for pitting (A). Check packing step for erosion (B). If pitting or erosion is observed, measure the depth of pits and erosion with a fine wire or needle. 16 Replace piston and liner if: Pitting depth is one-half liner thickness (C) or more. Specification Cylinder Liner Wall—Thickness 9.39—9.43 mm (0.370—0.371 in.) .......... Erosion depth is one-half packing step (D) or more.
RG4643 –UN–05DEC97 Specification Cylinder Liner Packing Step— Dimension 2.14—2.30 mm (0.084—0.090 in.) ............................................ NOTE: Liners are reusable if the depth of pits or erosion is less than one-half the amount specified. When installing these liners, rotate 90 ° from original position. The liners should be deglazed and ring sets installed on pistons. Liner Visual Inspection A—Liner Pitting B—Erosion C—Pitting Depth Is One-Half Liner Thickness D—Erosion Depth Is One-Half Packing Step Continued on next page RG,RG34710,110 –19–03AUG99–1/2 CTM100 (06APR04) 02-030-16 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=156