Deglaze Cylinder Liners 1. Secure cylinder liner in a holding fixture. See DFRG3— CYLINDER LINER HOLDING FIXTURE, in Section 05, Group 190 for assembly of holding fixture. 2. Use D17006BR Flexible Cylinder Hone to deglaze cylinder liner. NOTE: Use honing oil along with flex hone when deglazing liners. R26164 –UN–13DEC88 Deglazing Liners CTM100 (06APR04) 02-030-17 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,111 –19–30SEP97–1/2 040604 PN=157 Cylinder Block, Liners, Pistons, and Rods 2. Visually examine liner ID. Replace piston and liner if: • The crosshatch honing pattern is not visible immediately below the top ring turn-around area.
• Liners are pitted or contain deep vertical scratches that can be detected by the fingernail. 3. Carefully examine liner for signs of fatigue, such as fine cracks in the flange area (A) and cracks in the ring travel area (B). NOTE: Inspect block for cracks or erosion in the O-ring packing areas. (See INSPECT AND CLEAN CYLINDER BLOCK, later in this group.) –UN–04DEC97 4. Measure liner OD and compare to following specifications. RG1188 Cylinder Liners—Specification Flange Area—OD.................................................. 151.565—151.615 mm (5.9671—5.9691 in.) Liner ID Inspection Upper OD for Seating Liner—OD.........................
145.795—145.845 mm (5.7400—5.7419 in.) A—Cracks In The Flange Area Water Jacket Area—OD............................................ 144.73—144.99 mm B—Cracks In The Ring Travel Area (5.698—5.708 in.) Lower OD for Seating with O-Rings—OD......................................................... 140.397—140.447 mm (5.5274—5.5294 in.) RG,RG34710,110 –19–03AUG99–2/2 02 030 17