Cylinder Block, Liners, Pistons, and Rods Disassemble Piston/Rod Assembly and Clean Piston NOTE: Piston and ring sizes differ between engines. Piston part numbers are marked on top of pistons for identification. 02 030 20 RG8400 –UN–22MAY98 Removing Piston Pin Snap Ring 1. If necessary, check piston ring end gap prior to removing rings. Specification No. 1 Piston Compression Ring (4-mm Rings)—End Gap 0.43—0.69 mm (0.017—0.027 in.) ..................... No. 2 Piston Compression Ring (4-mm Rings)—End Gap 1.01—1.27 mm (0.040—0.050 in.) ..................... No. 1 Piston Compression Ring (3-mm Rings)—End Gap 0.48—0.74 mm (0.019—0.029 in.) ..................... No.
2 Piston Compression Ring (3-mm Rings)—End Gap 1.35—1.65 mm (0.053—0.065 in.) ..................... 2. Remove piston snap rings. Remove piston pin and connecting rod from piston. NOTE: Discard snap rings. DO NOT reuse. Continued on next page RG,RG34710,114 –19–01NOV00–1/2 CTM100 (06APR04) 02-030-20 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=160 Early Engines Engine Piston Ring Size 10.5 L RE52836, RE504801 4 mm 12.5 L RE66125 4 mm Later Engines 10.5 L RE504343 3 mm 12.5 L RE503969, RE505901 3 mm