Delphi — Inspect Piston Pin and Pin Bore in Piston

CTM100 (06APR04) 02-030-25 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=165 Cylinder Block, Liners, Pistons, and Rods Inspect Piston Pin and Pin Bore in Piston NOTE: Piston pin must be in good condition and not worn beyond specification given below. 1. Dip piston pin in clean engine oil. –UN–05DEC97 NOTE: On 6125 engines, assemble piston crown and skirt. RG5231 2. Install pin (A) through piston. Installing Piston Pin Pin should pass through piston using only light thumb pressure. 3. Check taper in piston pin bore by inserting pin from both sides. If pin enters freely, but binds in the center, the bore could be tapered (B). 4. Insert pin in piston to check for bore alignment.

Pin –UN–05DEC97 should not “click” or need to be forced into bore on opposite side (C). RG4984 5. Measure piston pin and piston bore and compare to specifications. If either are not within specification, replace pin, piston, and liner. Piston Pin Bore Inspection A—Pin Specification B—Tapered Bore Piston Pin—OD......................................................... 50.772—50.787 mm C—Opposite Side of Bore (1.9989—1.9995 in.) Piston Pin Bore in Piston (6105)—ID................................................................. 50.795—50.805 mm (1.9998—2.0002 in.) Piston Skirt Bushing (6125)—ID...............................

50.798—50.808 mm (1.9999—2.0003 in.) Piston Crown Bushing (6125)—ID............................ 50.810—50.825 mm (2.0004—2.0010 in.) RG,RG34710,118 –19–13AUG99–1/1 02 030 25