Cylinder Block, Liners, Pistons, and Rods Check Piston Oil Control Ring Groove Wear—6105 and 6125 Engines NOTE: Piston and ring sizes differ between engines. Piston part numbers are marked on top of pistons for identification. 02 030 24 RG5234 –UN–05DEC97 Measuring Oil Control Ring Groove Wear 1. Check oil control ring-to-groove clearance by installing a new ring in groove. 2. Measure clearance with a feeler gauge at several points. Compare measurements with specifications given below. Specification Oil Control Ring-to-Groove (RE52836, RE504801, RE66125 Pistons)—Clearance 0.064—0.114 mm (0.0025—0.0045 in.) ......................................................
Maximum Clearance 0.165 mm (0.0065 in.) ............................................... Oil Control Ring-to-Groove (RE504343, RE503969 and RE505901 Pistons)—Clearance 0.041—0.091 mm (0.0016—0.0036 in.) .................................... Maximum Clearance 0.132 mm (0.0052 in.) ............................................... NOTE: Replace piston and liner (as a set) if oil control ring clearance exceeds specifications given.
RG,RG34710,117 –19–01NOV00–1/1 CTM100 (06APR04) 02-030-24 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=164 Early Engines Engine Piston Oil Control Ring Size 10.5 L RE52836, RE504801 4.8 mm 12.5 L RE66125 4.8 mm Later Engines 10.5 L RE504343 4 mm 12.5 L RE503969, RE505901 4 mm