Delphi — Check Piston Compression Ring Groove Wear—6125 Engines

CTM100 (06APR04) 02-030-23 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=163 Cylinder Block, Liners, Pistons, and Rods Check Piston Compression Ring Groove Wear—6125 Engines NOTE: Earlier engines with and RE66125 pistons have 4-mm compression rings. Later engines with RE503969 and RE505901 pistons have 3-mm compression rings. Piston part numbers are marked on top of pistons for identification. –UN–10DEC97 The illustrations to the right shows use of JDG1022 Wear Gauge on earlier pistons. Use of JDG1335 on later pistons is similar except the two compression ring grooves are the same on these RG8522 pistons and only one side of the gauge is used to check both.

Using JDG1022 - Top Groove Check grooves at several locations around the circumference of piston crown. The word “TOP” on gauge should always face top of piston. Earlier RE66125 Pistons with 4-mm Rings: Use the JDG1022 Ring Groove Wear Gauge (A), end marked “G1”, to check wear of top compression ring groove. –UN–10DEC97 Use end marked “G2” of JDG1022 Ring Groove Wear Gauge to check wear of middle compression ring groove. If gauge shoulder contacts ring land of piston, ring groove RG8523 is worn. Replace piston and liner as a set. Using JDG1022 - Second Groove If ring grooves are good (B), proceed with piston inspection.

A—JDG1022 Ring Groove Wear Gauge B—Piston with Good Ring Groove Later RE503969 and RE505901 Pistons with 3-mm C—Acceptable Clearance D—Piston with Worn Ring Groove Rings: E—Gauge Shoulder Contacting Piston Ring Land Use JDG1335 Ring Groove Wear Gauge to check wear of top two compression rings. If gauge shoulder contacts ring land of piston, ring groove is worn. Replace piston and liner as a set. If ring grooves are good (B), proceed with piston inspection. RG,RG34710,116 –19–01NOV00–1/1 02 030 23