Cylinder Block, Liners, Pistons, and Rods Check Piston Compression Ring Groove Wear—6105 Engines NOTE: Earlier engines with RE52836 and RE504801 pistons have 4-mm compression rings. Later engines with RE504343 pistons have 3-mm compression rings. Piston part numbers are marked on top of pistons for identification. 02 030 22 RG8373 –UN–21MAY98 Use the JDG1019 Ring Groove Wear Gauge on RE52836 and RE504801 pistons (early engines) to check wear of top two compression ring grooves. Use the JDG1335 Ring Groove Wear Gauge on RE504343 pistons (later engines) to check wear of top two compression ring grooves.
Checking 6105 Piston Ring Groove (JDG1019 Shown on RE52836 Piston) Check each groove at several locations. Gauge shoulders should not contact ring land (D) of piston. If ring grooves are worn, replace piston and liner as a set. If ring grooves are good, proceed with piston inspection. A—Piston with Worn Ring Groove B—Keystone Ring Groove C—JDG1019 Ring Groove Wear Gauge D—Ring Land E—Gauge Shoulder F—Piston with Good Ring Groove RGR24201 –UN–19NOV97 JDG1019 Ring Groove Wear Gauge Shown RG,RG34710,115 –19–01NOV00–1/1 CTM100 (06APR04) 02-030-22 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=162