CTM100 (06APR04) 02-030-29 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=169 Cylinder Block, Liners, Pistons, and Rods Inspect and Measure Connecting Rod Bearings Inspect rod bearings for damage of wear. IMPORTANT: Never use new connecting rod cap screws when checking rod bearing ID. Use new cap screws only for final assembly of connecting rods. Rod bearing-to-journal oil clearance can be checked with –UN–30JUL99 PLASTIGAGE, if rod is connected to crankshaft. If rod is out of engine, measure ID of connecting rod bearings and compare with OD of crankshaft journal. RG10246 NOTE: Use PLASTIGAGE as directed by the manufacturer.
The use of PLASTIGAGE will Assembled Rod with Bearing determine bearing journal clearance, but will not A—Rod Cap indicate the condition of either surface. B—Rod C—Bearings 1. With crankshaft removed, measure connecting rod journal OD at several points. 2. Install connecting rod cap (A) on rod (B) with bearings (C) in correct position. 3. On tongue-and-groove connecting rods: Initially tighten blind-hole cap screw, then, tighten open-hole cap screw to the following specifications. Specification Tongue-and-Groove Connecting Rod Cap Screw—Initial Torque....................................... 27 N•m (20 lb-ft) Next, tighten rod cap screws to the following specifications.
Specification Tongue-and-Groove Connecting Rod Cap Screw—Final Torque............... 75 N•m (55 lb-ft) plus 90—100° turn clockwise (See TORQUE-TURN CONNECTING ROD CAP SCREWS, later in this group.) PLASTIGAGE is a registered trademark of DANA Corp. Continued on next page RG,RG34710,121 –19–13AUG99–1/3 02 030 29