Cylinder Block, Liners, Pistons, and Rods 4. On PRECISION JOINT connecting rods : Initially tighten rod cap screw closest to piston end, then tighten other cap screw to the following specifications. 02 030 Specification PRECISION JOINT Connecting Rod Cap Screw—Torque 140 (103 lb-ft) plus 90—100 ° turn clockwise .................... 30 (See TORQUE-TURN CONNECTING ROD CAP SCREWS, later in this group.) PRECISION JOINT is a trademark of Deere & Company RG,RG34710,121 –19–13AUG99–2/3 5. Using an inside micrometer (A), measure assembled ID of bearing. 6. Subtract OD of each crankshaft journal from ID of each respective rod bearing to obtain oil clearance. RG3824 –UN–04DEC97 7.
Compare measurements with the specifications given. Specification Crankshaft Rod Journal—OD 88.844—88.874 mm (3.4980—3.4990 in.) .................................... Connecting Rod Bearing for Crankshaft Journal (Assembled)—ID 88.93—88.98 mm (3.501—3.502 in.) ................................... Measuring Assembled Rod Bearing ID Connecting Rod Bearing-to-Journal (New Part)— Oil Clearance 0.06—0.13 mm (0.002—0.005 in.) ....................................... Max. Oil Clearance 0.15 mm (0.006 in.) ..................................................... A—Inside Micrometer 8. Inspect connecting rod bearings for wear or damage.
If bearings are worn or not within specification, replace both connecting rod bearing and rod pin bearing. RG,RG34710,121 –19–13AUG99–3/3 CTM100 (06APR04) 02-030-30 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=170