Delphi — Inspect Connecting Rod and Cap

CTM100 (06APR04) 02-030-31 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=171 Cylinder Block, Liners, Pistons, and Rods Inspect Connecting Rod and Cap 1. Inspect rod and cap for wear or damage, such as chips or nicks in the joint areas (A). IMPORTANT: DO NOT nick the joint surfaces of rod –UN–04DEC97 and cap. This is very critical on PRECISION JOINT rods to ensure proper seating. Never scrape joint surfaces (C) with a wire brush or other RG3749 tool; the interlocking mating surfaces must be preserved, and remain free of Tongue-and-Groove Rod and Cap any debris. Rod cap MUST be kept with parent rod. 2. Inspect in and around cap screw holes (B) in cap.

If any defects are found, replace rod and cap. –UN–27AUG99 IMPORTANT: If replacing a connecting rod, use the same type of joint design. DO NOT intermix PRECISION JOINT rods and tongue-and-groove rods on the same RG10301 engine. See parts catalog for recommendations. PRECISION JOINTRod and Cap A—Tongue-and-Groove Joints B—Cap Screw Hole C—PRECISION JOINTMating Surfaces PRECISION JOINT is a trademark of Deere & Company Continued on next page RG,RG34710,122 –19–02AUG99–1/4 02 030 31