Delphi — Inspect Connecting Rod and Cap

Cylinder Block, Liners, Pistons, and Rods 3. Carefully clamp rod in a soft-jawed vise (cap end upward). IMPORTANT: Never use new connecting rod cap screws when checking rod bearing ID. Use new cap screws only for final assembly of connecting rods. 02 030 32 RG4982 –UN–05DEC97 4. Install cap WITHOUT bearing inserts. 5. On tongue-and-groove connecting rods : Initially tighten blind-hole cap screw, then, tighten open-hole cap screw to the following specifications. Assembled Rod Without Bearings Specification Tongue-and-Groove Connecting Rod Cap Screw—Initial Torque 27 (20 lb-ft) ....................................... Next, tighten rod cap screws to the following specifications.

Specification Tongue-and-Groove Connecting Rod Cap Screw—Final Torque 75 (55 lb-ft) plus 90—100 ° turn clockwise ............... (See TORQUE-TURN CONNECTING ROD CAP SCREWS, later in this group.) 6. On PRECISION JOINT connecting rods : Initially tighten rod cap screw closest to piston end, then tighten other cap screw to the following specifications. Specification PRECISION JOINT Connecting Rod Cap Screw—Torque 140 (103 lb-ft) plus 90—100 ° turn clockwise ....................

(See TORQUE-TURN CONNECTING ROD CAP SCREWS, later in this group.) PRECISION JOINT is a trademark of Deere & Company Continued on next page RG,RG34710,122 –19–02AUG99–2/4 CTM100 (06APR04) 02-030-32 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=172