CTM100 (06APR04) 02-030-35 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=175 Cylinder Block, Liners, Pistons, and Rods 4. Insert pin from either side of rod bushing. If pin is free on one end, but tight on the other, the bore could be tapered (A). If pin enters freely from both sides, but is tight in the center, bore is bell-mouthed (B). 5. Inspect piston pin bushing lubrication hole in rod for damage, excessive wear or contaminants. –UN–20NOV97 6. Measure pin bushing ID for specified clearance. Specification RG4924 Piston Pin—OD.........................................................
50.772—50.787 mm (1.9989—1.9995 in.) Inspecting Rod Piston Pin Bushing Bore Rod Pin Bore Without Bushing— ID............................................................................... 55.529—55.555 mm A—Tapered Bore (2.1862—2.1872 in.) B—Bell-Mouthed Bore Installed Rod Pin Bushing (Before Boring)—ID................................................................ 50.729—50.781 mm (1.9972—1.9992 in.) Installed Rod Pin Bushing (After Boring)—ID................................................................ 50.805—50.830 mm (2.0002—2.0012 in.) Piston Pin Bushing Bore— Out-of-Round..........................................................
0.038 mm (0.0015 in.) Piston Pin-to-Bushing—Oil Clearance...................................................................... 0.017—0.059 mm (0.0007—0.0023 in.) Max. Acceptable Wear........................................... 0.076 mm (0.0030 in.) Press Fit of Bushing in Rod Pin Bore—Press Fit............................................................. 0.100—0.163 mm (0.0039—0.0064 in.) 7. If necessary, remove and replace piston pin bushing. (See REMOVE PISTON PIN BUSHING, CLEAN, AND INSPECT BUSHING BORE in this group.) RG,RG34710,123 –19–13AUG99–2/2 02 030 35