Delphi — Remove Piston Pin Bushing, Clean, and Inspect Bushing Bore

Cylinder Block, Liners, Pistons, and Rods Remove Piston Pin Bushing, Clean, and Inspect Bushing Bore IMPORTANT: Do not use pneumatic tools to remove or install piston pin bushing. 02 030 36 Use care to properly align the JDE98-10 Bushing Remover/Installer (B) with bushing so that the connecting rod is not damaged. RG4723 –UN–20NOV97 1. Remove the used bushing with JDE98-8 Cup (A), JDE98-10 Bushing Remover/Installer, and STD36104 Forcing Screw (C) from the JDE98A Connecting Rod Bushing Service Set. Removing Rod Piston Pin Bushing A—JDE98-8 Cup B—JDE98-10 Bushing Remover/Installer C—STD36104 Forcing Screw 2. Clean rod bushing bore using a medium grit emery cloth, as burrs will distort bushing.

Install bushing on side opposite rod burr. 3. If necessary, file a slight chamfer around bushing bore to remove any sharp edges. Chamfer will also aid in bushing installation. 4. Measure rod bushing bore in three or more places approximately 45 ° apart. Specification Connecting Rod Pin Bushing Bore (Without Bushing)—ID 55.529—55.555 mm (2.1862—2.1872 in.) ...................................... Connecting Rod Pin Bushing— Press Fit in Rod Pin Bore 0.100—0.163 mm (0.0039—0.0064 in.) ............................................. IMPORTANT: If piston pin bushing bore diameter is not within specification or bushing has spun in rod, discard rod and replace with a new one.

RG,RG34710,124 –19–30SEP97–1/1 CTM100 (06APR04) 02-030-36 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=176