Cylinder Block, Liners, Pistons, and Rods NOTE: Keystone compression ring with one mark goes in top piston ring groove and keystone ring with two marks goes in second ring groove of piston. mark(s) must face top of piston. 02 030 IMPORTANT: Pistons and ring sets differ between engines. Piston part numbers are marked on top of pistons for identification. Ensure correct size rings are installed on appropriate pistons. DO NOT intermix rings. 48 5. Use the JDG967 Ring Expander to install compression rings (D) and oil control ring with expander ring (E). RG,RG34710,132 –19–01NOV00–2/2 Install Pistons and Connecting Rods IMPORTANT: Replace rods with the same type.
Do Not mix tongue-and-groove with PRECISION JOINT rods in the same engine. See parts catalog for recommendations. RG10300 –UN–27AUG99 Earlier engines have the traditional tongue-and-groove between the connecting rod and cap (A). Later engines have the PRECISION JOINT rod and cap (B). Both types of rods provide a strong joint. Installation is similar, with differences noted, including different torque specifications for cap screws.
Connecting Rods A—Tongue-and-Groove Rod (Early Engines) B—PRECISION JOINT Rod (Later Engines) CTM100 (06APR04) 02-030-48 P OWER T ECH 10.5 L & 12.5 L Diesel Engines PRECISION JOINT is a trademark of Deere & Company Continued on next page RG,RG34710,133 –19–26AUG02–1/6 040604 PN=188 Early Engines Engine Piston Compression Ring Size Oil Control Ring Size 10.5 L RE52836, RE504801 4 mm 4.8 mm 12.5 L RE66125 4 mm 4.8 mm Later Engines 10.5 L RE504343 3 mm 4 mm 12.5 L RE503969, RE505901 3 mm 4 mm