CTM100 (06APR04) 02-030-47 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=187 Cylinder Block, Liners, Pistons, and Rods Assemble Pistons and Connecting Rods NOTE: Piston and liner sets differ between engines. DO NOT mix piston and liner sets. See parts catalog for correct applications. IMPORTANT: Pistons must be installed on same –UN–09DEC97 connecting rods from which they were removed and NEW piston pin snap rings must be used. RG8401 If a new piston and liner assembly is to be installed, DO NOT remove piston 6125 Piston Crown and Skirt from liner. Push piston out of liner bottom only far enough to install piston pin. 1.
On 6125 engines, assemble piston crown (A) and skirt (B) so that connecting rod pin bushings are aligned. –UN–22MAY98 2. Lubricate piston pin and bushings with clean engine oil. NOTE: Pistons are symmetrical; new pistons can be installed either way. If pistons are being reused, RG8400A align front reference mark made during disassembly with front of connecting rod. Assembling Piston and Rod 3. Install piston pin through piston and connecting rod A—Piston Steel Crown (6125 Engine) (C). B—Piston Skirt (6125 Engine) C—Connecting Rod 4. Install NEW piston pin snap rings in grooves.
Make D—Compression Rings (2 used) E—Oil Control Ring certain snap rings have completely expanded in grooves of piston. Sharp edge of snap ring MUST face toward outside of piston. Continued on next page RG,RG34710,132 –19–01NOV00–1/2 02 030 47