Delphi — Install Cylinder Liners

Cylinder Block, Liners, Pistons, and Rods NOTE: Cylinder liner will protrude over top of cylinder block more than normal due to uncompressed packings and O-rings. 02 030 3. Finish seating cylinder liners using a clean hardwood block and hammer as shown in top figure or by using JDG1145 Liner Service Set (B) and a 2.27 kg (5 lb) slide hammer (A) shown in lower figure. 46 T48319 –UN–23FEB89 Using either method, apply only enough force as necessary to seat liners. IMPORTANT: If you suspect that a packing may have sheared or displaced during liner installation, remove liner and packing assembly. If no damage is found, check packing and O-rings for proper position.

Resoap packings and reinstall liner assembly. Seating Liner 4. Hold liners in place with large flat washers and cap screws. Turn cap screws snug, but do not tighten. RG10342 –UN–10SEP99 5. Clean cylinder liner bores with waterless hand cleaner after installation. Wipe dry with clean towels. JDG1145 Liner Service Set 6. Apply clean engine oil to liner bores immediately to prevent corrosion. A—Slide Hammer B—Liner Service Set RG,RG34710,131 –19–01NOV00–2/2 CTM100 (06APR04) 02-030-46 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=186