Delphi — Install Pistons and Connecting Rods

Cylinder Block, Liners, Pistons, and Rods 5. Carefully place ring compressor with piston and rod over liner. IMPORTANT: Be sure crankshaft journals and liner walls are not damaged when installing piston and rod liner. 02 030 50 NOTE: Be sure the word “FRONT” on connecting rod faces toward the front of the engine. RG8366 –UN–21MAY98 6. With piston centered in ring compressor and rings staggered correctly, push piston into liner. Installing Piston and Rod Assembly RG,RG34710,133 –19–26AUG02–4/6 7. Apply clean engine oil to bearing inserts (B) and crankshaft rod journals (A). IMPORTANT: On PRECISION JOINT rods, make sure bearings are properly centered in the cap and rod.

Make sure cap is properly aligned on rod, with interlocking surfaces sealing tightly and edges aligned. DO NOT reverse cap on rod. Match pads on side of rod and cap. RG8409B –UN–09DEC97 When installing caps, make sure stamped numbers on rod and cap are positioned on the same side. Installing Rod Caps NEVER use connecting rod cap screws more than once for final engine assembly. Once rod cap screws have been tightened to final torque-turn specifications, they cannot be reused for final assembly. RG8396 –UN–21MAY98 8. Install connecting rod caps.

A—Crankshaft Rod Journals B—Bearing Inserts Tightening Rod Caps CTM100 (06APR04) 02-030-50 P OWER T ECH 10.5 L & 12.5 L Diesel Engines PRECISION JOINT is a trademark of Deere & Company Continued on next page RG,RG34710,133 –19–26AUG02–5/6 040604 PN=190