Delphi — Install Pistons and Connecting Rods

CTM100 (06APR04) 02-030-51 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=191 Cylinder Block, Liners, Pistons, and Rods 9. Dip new cap screws and washers in clean engine oil. Make sure tops of cap screws have oil on them also. IMPORTANT: DO NOT use pneumatic wrenches to install connecting rod cap screws. Doing so may damage threads. Use –UN–05DEC97 speed-handle wrench instead. 10. On tongue-and-groove connecting rods: Initially, tighten blind-hole cap screw (A) to specifications. RG4375 Next, tighten the other cap screw. Feel rod-to-cap joint to check for proper alignment.

Tightening Rod Cap Screws Specification A—Blind-Hole Cap Screw Tongue-and-Groove Connecting Rod Cap Screw—Initial Torque....................................... 27 N•m (20 lb-ft) Second, tighten all cap screws to the following specifications, then torque-turn all cap screws 90—100°. Specification Tongue-and-Groove Connecting Rod Cap Screw—Final Torque............... 75 N•m (55 lb-ft) plus 90—100° turn clockwise (See TORQUE-TURN CONNECTING ROD CAP SCREWS, next in this group.) 11. On PRECISION JOINT connecting rods: Initially, tighten cap screw closest to piston end to specifications. Next, tighten the other cap screw. Feel rod-to-cap joint to check for proper alignment.

Specification PRECISION JOINTConnecting Rod Cap Screw—Torque.................... 140 N•m (103 lb-ft) plus 90—100° turn clockwise (See TORQUE-TURN CONNECTING ROD CAP SCREWS, next in this group.) PRECISION JOINT is a trademark of Deere & Company RG,RG34710,133 –19–26AUG02–6/6 02 030 51