Crankshaft, Main Bearings, and Flywheel Remove Crankshaft Vibration Damper and Pulley CAUTION: Damper and pulley are very heavy. Plan proper handling procedures to avoid injury. ALWAYS use an assistant when removing and installing pulley. 02 040 4 RG8175A –UN–05DEC97 IMPORTANT: DO NOT immerse damper assembly in petroleum products (such as gasoline, oil, solvent, etc.). Doing so can damage the rubber portion of the assembly. Never apply thrust on outer ring of damper. The damper is sensitive to impact damage from being dropped or struck with a hammer. Removing Damper Retaining Ring NOTE:
Remove front bolt-on pulley from vibration damper assembly for access to front nose of crankshaft, if equipped. RG8176 –UN–05DEC97 1. Remove six cap screws and large washer (A) from front nose of crankshaft. 2. Install JDG973-1 Remover/Installer Hub (B) onto nose of crankshaft with two hex socket head cap screws provided in kit. Tighten cap screws until they bottom on hub. Installing JDG973-1 Hub A—Large Washer B—JDG973-1 Remover/Installer Hub 3. Lubricate threads of remover/installer with multi-purpose grease. Continued on next page RG,RG34710,151 –19–30SEP97–1/2 CTM100 (06APR04) 02-040-4 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=200