Remove Crankshaft Front Oil Seal 1. Remove vibration damper and pulley. (See REMOVE CRANKSHAFT VIBRATION DAMPER AND PULLEY, earlier in this group.) 2. Remove eight cap screws and remove front seal from timing gear cover. RG8119 –UN–21MAY98 For front crankshaft oil seal replacement, oil seal must be installed onto vibration damper prior to damper installation. (See INSTALL CRANKSHAFT VIBRATION DAMPER AND FRONT OIL SEAL, later in this group.) Removing Crankshaft Front Oil Seal RG,RG34710,152 –19–30SEP97–1/1 CTM100 (06APR04) 02-040-5 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=201 Crankshaft, Main Bearings, and Flywheel 4.
Thread large hex nut (A) onto hub and install thrust washer (B). Grease both sides of thrust washer. 5. Install JDG973-2 Cross Block (C) and secure with two hex head cap screws provided in kit. Thread cap screws into vibration damper deep enough to allow clearance for wrench on large nut. –UN–05DEC97 6. Remove damper from crankshaft flange. Remover/installer hub will support damper after it is removed from crankshaft flange. RG8168 7. Remove hub from front nose of crankshaft. Installing JDG973-2 Cross Block A—Large Hex Nut B—Thrust Washer C—JDG973-2 Cross Block –UN–05DEC97 RG8169 Removing Vibration Damper RG,RG34710,151 –19–30SEP97–2/2 02 040 5