Crankshaft, Main Bearings, and Flywheel Remove Timing Gear Cover 1. If not previously done, remove vibration damper and pulley (A). (See REMOVE CRANKSHAFT VIBRATION DAMPER AND PULLEY, earlier in this group.) 02 040 6 2. Drain engine oil if not previously done and remove engine oil pan (B). (See REMOVE ENGINE OIL PAN in Group 060.) RG8178 –UN–05DEC97 3. Disconnect crankshaft position sensor. NOTE: On engines with fixed fan drive assembly, the fan drive housing is cast into the camshaft gear access cover. Removing Timing Gear Cover A—Vibration Damper B—Oil Pan C—Fan Drive Assembly D—Camshaft Gear Access Cover E—Timing Gear Cover 4. Remove fan drive assembly (C).
(See REPLACE BEARINGS IN FAN DRIVE ASSEMBLY in Group 070.) NOTE: Mark location of cap screws to aid in reassembly. 5. Remove camshaft gear access cover (D) from timing gear cover. Mark location of cap screws to aid in reassembly. 6. Remove remaining cap screws and remove timing gear cover. Mark location of cap screws to aid in reassembly. NOTE: On engines with fixed fan drive, the lower right cap screw (under pulley) will have to be reinstalled in camshaft gear access cover bore prior to installing pulley. Once pulley is installed, it interferes with the installation of this cap screw.
RG,RG34710,153 –19–12SEP02–1/1 CTM100 (06APR04) 02-040-6 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=202