CTM100 (06APR04) 02-040-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=203 Crankshaft, Main Bearings, and Flywheel Check Flywheel Housing Face Runout 1. Mount dial indicator on flywheel. Set pointer to contact PTO mounting surface on flywheel housing at right angles (A). Pointer should not contact holes in flywheel housing. –UN–02AUG99 IMPORTANT: Maintain constant end pressure on crankshaft to hold shaft against thrust bearing when measuring flywheel RG10271 housing face runout. 2. Rotate flywheel by turning crankshaft. Read total dial Face Deviation indicator movement and compare to specifications. 3. Remount set pointer to contact flywheel housing inner bore (B). 4.
Rotate flywheel by turning crankshaft. Read total dial indicator movement and compare to specifications. –UN–02AUG99 Specification SAE 1 Flywheel Housing— Maximum Face Deviation (A)..................................... 0.30 mm (0.012 in.) RG10272 Maximum Bore Eccentricity (B).................................. 0.30 mm (0.012 in.) SAE 2 Flywheel Housing— Maximum Face Deviation (A)..................................... 0.28 mm (0.011 in.) Bore Eccentricity Maximum Bore Eccentricity (B).................................. 0.28 mm (0.011 in.) SAE 0 Flywheel Housing— A—Measure Face Deviation Maximum Face Deviation (A).....................................
0.41 mm (0.016 in.) B—Measure Bore Eccentricity Maximum Bore Eccentricity (B).................................. 0.41 mm (0.016 in.) RG,RG34710,154 –19–12SEP02–1/1 02 040 7