Crankshaft, Main Bearings, and Flywheel Check Flywheel Face Flatness 1. Mount dial indicator base on flywheel housing. Position pointer to contact driving ring mounting surface. Do not allow pointer to contact driving ring mounting holes. 02 040 8 IMPORTANT: Maintain constant end pressure on crankshaft to hold shaft against thrust bearing when measuring flywheel face flatness. R22213 –UN–14DEC88 2. Rotate flywheel by turning crankshaft. Read total dial indicator movement. Resurface flywheel face or replace as required. Measuring Flywheel Face Flatness Specification Flywheel Face Flatness— Maximum Variation 0.23 mm (0.009 in.) .....................................................
Maximum Variation per 25 mm (1.0 in.) of Travel 0.013 mm (0.0005 in.) .................................................... RG,RG34710,155 –19–05SEP02–1/1 Remove Flywheel CAUTION: Flywheel is heavy. Use proper lifting procedures to avoid personal injury. NOTE: SAE 1 flywheel housing must be removed before flywheel can be removed from engine. (See REMOVE AND INSTALL FLYWHEEL HOUSING, later in this group.) RG8134A –UN–05DEC97 1. Remove two flywheel attaching cap screws (A), and install two guide pins in their place. 2. Remove remaining cap screws, and carefully pull flywheel from crankshaft. Removing Flywheel A—Cap Screws B—Threaded Guide Pins NOTE:
Threaded guide pins (B) may also be used to ease handling of flywheel. Once flywheel is removed, JDG976 Crankshaft Front Rotation Adapter can be used to rotate crankshaft if necessary. CTM100 (06APR04) 02-040-8 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,156 –19–27JUL99–1/1 040604 PN=204