Crankshaft, Main Bearings, and Flywheel Replace Flywheel Ring Gear CAUTION: Oil fumes or oil can ignite above 193 ° C (380 ° F). Do not allow a flame or heating element to be in direct contact with the oil. Heat the oil in a well ventilated area. Plan a safe handling procedure to avoid burns. 02 040 10 T90596 –UN–14OCT88 1. Place the flywheel on a solid flat surface. 2. Drive ring gear off with a brass drift and hammer. Removing Flywheel Ring Gear IMPORTANT: If flame heat is used, be sure gear is heated uniformly around circumference. DO NOT OVERHEAT above 232 ° C (450 ° F). SEE CAUTION. Overheating may also destroy original heat treatment of gear. 3.
Heat new ring gear sufficiently to allow gear to fit flywheel hub without interference, but do not heat above 232 ° C (450 ° F) maximum, using either heated oil or oven heat. RG3838 –UN–14OCT88 4. Turn gear so side with chamfer (A) is toward engine with flywheel installed. Flywheel Ring Gear A—Chamfer 5. Install ring gear flush within 0.25 mm (0.010 in.) against shoulder of flywheel. Ring gear will shrink to required fit as it cools. RG,RG34710,158 –19–17DEC00–1/1 CTM100 (06APR04) 02-040-10 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=206