Delphi — Remove and Install Flywheel Housing

CTM100 (06APR04) 02-040-11 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=207 Crankshaft, Main Bearings, and Flywheel Remove and Install Flywheel Housing Remove Flywheel Housing 3. Dip threads of cap screw in engine oil before installing. Install and tighten cap screws to specifications. CAUTION: Flywheel housing is heavy. Plan a proper lifting procedure to avoid personal Specification injury. Flywheel Housing-to-Cylinder Block Cap Screws (SAE 1 With NOTE: Flywheel must be removed before removing Rear PTO)—Torque............................................. 325 N•m (240 lb-ft) SAE 0 and SAE 2 flywheel housings.

(See Flywheel Housing-to-Cylinder Block Cap Screws (SAE 0, 1 REMOVE FLYWHEEL earlier in this group.) and 2 Without Rear PTO)— Torque................................................................... 365 N•m (270 lb-ft) 1. Remove attaching cap screws. 4. Install flywheel housing front plate and timing hole 2. Remove flywheel housing. covers, if removed. Tighten cap screws to specifications. 3. Inspect dowel pins for damage. Replace pins as needed. Specification Flywheel Housing Front Plate Install Flywheel Housing Cap Screws—Torque...............................................

50 N•m (37 lb-ft) Flywheel Housing Timing Hole Cover Cap Screws—Torque......................................5 N•m (44 lb-in.) CAUTION: Flywheel housing is heavy. Plan proper lifting procedures to avoid personal 5. If removed, install starter motor and tighten cap injury. screws to specifications. 1. Scrape off all old gasket material. Install a new Specification Starter Motor Cap Screws— gasket without sealant between block and flywheel Torque..................................................................... 125 N•m (92 lb-ft) housing, if equipped. 2. Install flywheel housing on cylinder block. NOTE: ALWAYS use new cap screws when installing flywheel housing.

RG,RG34710,159 –19–23OCT00–1/1 02 040 11