Delphi — Install Flywheel

Crankshaft, Main Bearings, and Flywheel Install Flywheel CAUTION: Flywheel is heavy. Plan proper handling procedures to avoid injuries. 02 040 NOTE: SAE 0 and SAE 2 flywheel housings must be installed before installing flywheel. (See REMOVE AND INSTALL FLYWHEEL HOUSING earlier in this group.) 12 RG8134 –UN–21MAY98 NOTE: ALWAYS use new cap screws when installing flywheel. Installing Flywheel 1. Install two pilot studs in crankshaft to aid in assembly. Position flywheel over pilot studs. 2. Install flywheel attaching cap screws. Remove pilot studs and install remaining two cap screws. 3. Tighten flywheel attaching cap screws in the sequence shown to the following specifications.

RG10248 –UN–30JUL99 Specification Flywheel-to-Crankshaft Cap Screws—Torque 130 (96 lb-ft) ............................................................ Flywheel Tightening Sequence 4. After flywheel and housing are installed, perform flywheel-to-housing runout checks. (See CHECK FLYWHEEL HOUSING FACE RUNOUT earlier in this group.) RG,RG34710,160 –19–27JUL99–1/1 CTM100 (06APR04) 02-040-12 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=208