Delphi — Check Main Bearing-to-Journal Oil Clearance

Crankshaft, Main Bearings, and Flywheel Check Main Bearing-to-Journal Oil Clearance NOTE: The use of PLASTIGAGE will determine wear (crankshaft-to-bearing oil clearance) but will not determine condition of either bearing or journal surface. 02 040 18 1. Place a strip of PLASTIGAGE in the center of the main bearing cap about three-fourths of the width of the bearing. RG8128 –UN–21MAY98 2. Use clean SAE 30 engine oil on PLASTIGAGE to prevent sticking. Checking Oil Clearance 3. Install cap and tighten cap screws to specification. Specification Crankshaft Main Bearing Cap Screws—Final Torque 320 (236 lb-ft) ................................................. 4.

Remove cap and compare width of PLASTIGAGE with specifications below to determine clearance. Specification Crankshaft Main Bearings—Main Bearing-to-Journal Clearance 0.046—0.122 mm (0.0018—0.0048 in.) ........................................ Maximum Acceptable Oil Clearance 0.152 mm (0.0060 in.) ............................................................... PLASTIGAGE is a registered trademark of DANA Corp. RG,RG34710,163 –19–12SEP02–1/1 CTM100 (06APR04) 02-040-18 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=214