Delphi — Inspect Crankshaft

Crankshaft, Main Bearings, and Flywheel CAUTION: Crankshaft is very heavy. Plan a proper handling procedure to avoid injury. 9. Attach a lifting strap to crankshaft. Protect machined journals from damage with clean shop towels. 02 040 20 10. Using proper lifting equipment, carefully raise crankshaft out of cylinder block. RG8200 –UN–21MAY98 11. Clean crankshaft, especially oil passages, using solvent and compressed air. Removing Crankshaft from Block 12. Put crankshaft on clean V-blocks for inspection. RG,RG34710,164 –19–13AUG99–2/2 Inspect Crankshaft NOTE: If crankshaft damper damage was discovered during teardown, it is recommended that the crankshaft be magna-fluxed.

This will verify whether or not it has microscopic cracks or fissures. (See INSPECT CRANKSHAFT VIBRATION DAMPER, earlier in this group.) (See REPLACE CRANKSHAFT DRIVE GEAR, later in this group.) 4. Inspect the keyway for evidence of cracks or wear. Replace crankshaft as necessary. 1. Thoroughly clean crankshaft. Clear restrictions from all oil passages. 5. Carefully inspect the rear flange of the crankshaft in the area of the oil seal’s wear sleeve contact surface for evidence of a rough or grooved condition. Any imperfections in this area will result in oil leakage. Slight ridges may be cleaned up with emery cloth and crocus cloth. 2.

Inspect crankshaft for signs of load stress, cracks, or scratches on journals. Also check each journal for evidence of excessive overheating or discoloration. If either condition exists, replace crankshaft, since heat treatment has probably been destroyed. 6. Check each journal for evidence of excessive overheating or discoloration. If either condition exists, replace crankshaft, since heat treatment has probably been destroyed. 3. Inspect (front) crankshaft gear and timing wheel for cracks, chipped teeth, or excess wear. Inspect keyway and index pin for damage and proper indexing on flange. Replace gear(s) as required. IMPORTANT:

The vibration damper MUST BE replaced whenever the crankshaft is replaced. CTM100 (06APR04) 02-040-20 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,165 –19–13AUG99–1/2 040604 PN=216