Crankshaft, Main Bearings, and Flywheel Measure Assembled ID of Bearings and OD of Crankshaft Journals 1. With crankshaft out of cylinder block, install main bearing inserts and caps (be sure inserts are installed correctly). 4. Measure OD of all respective crankshaft journals at several points around journal. 02 040 Specification Crankshaft Main Bearing Journal—OD 124.983—125.017 mm (4.9206—4.9219 in.) ................................................... 22 2. Tighten main bearing cap screws to specification. Specification Crankshaft Main Bearing Cap Screws—Final Torque 320 (236 lb-ft) .......................................... NOTE:
If engine has previously had a major overhaul and undersized bearing inserts were used, above listed ID and OD dimensions may not be the same as those recorded. However, oil clearance should be within specifications. Oil clearance is 0.046—0.122 mm (0.0018— 0.0048 in.). The maximum serviceable clearance is 0.152 mm (0.0060 in.). 3. Measure ID of all bearings with an inside micrometer and compare measurements with respective crankshaft main journals. Specification Crankshaft Main Bearing—ID With Bearing 125.071—125.127 mm (4.9241—4.9263 in.) ................................................... ID Without Bearing 133.097—133.123 mm (5.2400—5.2411 in.) .........................................
Compare crankshaft journal OD measurements to determine if journal is out-of-round or tapered. NOTE: Inspect and measure assembled ID of connecting rod bearings. Compare measurements with connecting rod journal OD on crankshaft. (See INSPECT AND MEASURE CONNECTING ROD BEARINGS in Group 030.) Specification Crankshaft Main Journal—Max. Out-of-Round 0.025 mm (0.0010 in.) ................................................... Max. Taper per 25.4 mm (1.0 in.) of Journal Length 0.0025 mm (0.0001 in.) ..................................... RG,RG34710,166 –19–05SEP02–1/1 CTM100 (06APR04) 02-040-22 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=218