Delphi — Measure Assembled ID of Main Bearing Caps (Without Bearings)

CTM100 (06APR04) 02-040-23 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=219 Crankshaft, Main Bearings, and Flywheel Measure Assembled ID of Main Bearing Caps (Without Bearings) 1. With crankshaft removed from cylinder block, install IMPORTANT: Main bearing cap line boring should main bearing caps without bearing inserts. be done ONLY by experienced personnel on equipment capable of 2. Tighten main bearing cap screws to specification. maintaining bore specifications. Specification 4. Measure main bearing cap surface width and Crankshaft Main Bearing Cap compare to following specifications. Screws—Final Torque..........................................

320 N•m (236 lb-ft) Specification 3. Measure ID of all bearing caps with an inside Crankshaft Main Bearing Cap— micrometer. Compare to specifications given. Surface Width......................................................... 39.75—40.25 mm (1.565—1.585 in.) If any main bearing cap assembled ID is not within specification, blank (generic) bearing caps are available and must be line bored to specification. Replace individual bearing caps as needed. Specification Main Bearing Cap Bore Specifications—ID Without Bearings.......................................................... 133.097—133.123 mm (5.2400—5.2411 in.) Max. Bore Diameter Variation.........................

0.013 mm (0.0005 in.) Max. Bore Diameter Taper.............................. 0.005 mm (0.0002 in.) Max. Straightness (Any Bore-to-Adjacent Bore).................................... 0.038 mm (0.0015 in.) Max. Straightness (5 Center Bores-to-Adjacent Bore).................................. 0.076 mm (0.0030 in.) Centerline of Bore-to-Top Deck.......................... 429.92—430.07 mm (16.926—16.932 in.) RG,RG34710,167 –19–05SEP02–1/1 02 040 23