Crankshaft, Main Bearings, and Flywheel Crankshaft Grinding Guidelines IMPORTANT: Crankshaft grinding should be done ONLY by experienced personnel on equipment capable of maintaining crankshaft size and finish specifications. IMPORTANT: Care must be taken to avoid localized heating which often produces grinding cracks. 02 040 24 4. Cool the crankshaft while grinding by using coolant generously. DO NOT crowd the grinding wheel into the work. If undersize bearings are used, check bearing clearance after bearing caps have been tightened to specified torque. If undersize bearings are too tight and clearance is not within specifications, the journal and bearing will be wiped clean of all oil.
This would result in premature wear of parts. IMPORTANT: Grind crankshaft with journals turning clockwise, as viewed from the front end of crankshaft. Lap or polish journals in opposite direction of grinding. 5. Polish or lap the ground surfaces to the specified finish to prevent excessive wear of the journals. In addition to the standard size main and connecting rod bearings, the following undersize bearings are available. NOTE: Production crankshafts are induction hardened and shotpeened at the factory. Field shotpeening is not recommended due to the equipment required and part geometry.
Specification Crankshaft Main Bearings Available—Undersize 0.25, 0.50 mm (0.010, 0.020 in.) ............................. 6. If the thrust surfaces of the crankshaft are worn or grooved excessively, regrind and polish. Maintain the specified radius between each thrust surface and the bearing journal. An oversize thrust washer set containing one standard washer and two 0.18 mm (0.007 in.) oversize washers is available. (See THRUST BEARING NEW PART SPECIFICATIONS, later in this group.) If journals are tapered, out-of-round, scored or damaged, grind the crankshaft and install the proper undersize bearings. If the crankshaft is to be reground, use the following recommended procedure: 1.
Compare the crankshaft journal measurements taken during inspection and determine the size to which the journals are to be reground. NOTE: When thrust surfaces are reground and oversize washers used, crankshaft end play specification must be maintained to within 0.038—0.380 mm (0.0015—0.0150 in.). (See CHECK CRANKSHAFT END PLAY, earlier in this group.) 2. If one or more main or connecting rod journals require grinding, then grind all of the main journals or all of the connecting rod journals to the same required size. 7. Stone the edges of all oil holes in the journal surfaces smooth to provide a radius of approximately 1.50 mm (0.060 in.). 3.
All journal fillet radii must be free of any sharp grind marks or scratches. The fillet must blend smoothly into the journal and crank cheek. Check the radius with a fillet gauge. CTM100 (06APR04) 02-040-24 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,168 –19–13AUG99–1/2 040604 PN=220