Delphi — Replace Crankshaft Drive Gear

Crankshaft, Main Bearings, and Flywheel Replace Crankshaft Drive Gear 02 040 26 RG8411 –UN–19MAY98 Crankshaft, Timing Wheel, Gear A—Crankshaft C—Woodruff Key D—Timing Wheel E—Crankshaft Drive Gear B—Roll Pin IMPORTANT: Crankshaft must be removed before replacing drive gear (E). IMPORTANT: Crankshaft gear must be installed on crankshaft before crankshaft is installed in engine, otherwise damage to thrust bearings could occur. NOTE: Remove crankshaft gear for replacement only; it is not necessary to remove gear for crankshaft removal. 1. Protect crankshaft machined wear sleeve surface with masking tape. 6. Heat crankshaft gear to 182 ° C (360 ° F) maximum, using either heated oil or oven heat.

2. Remove crankshaft gear using D01074AA 17-1/2 Ton Puller Set. 7. Install new roll pin in crankshaft and position timing wheel over roll pin for proper indexing. 8. Install Woodruff key in crankshaft keyway. 3. Discard gear after removal. 4. Remove Woodruff key (C), crankshaft timing wheel (D), and roll pin (B) from crankshaft keyway. 9. Place gear on crankshaft flange. Be sure key on crankshaft is properly aligned with keyway in gear. IMPORTANT: When installing gear, do not gouge or nick crankshaft flange. 5. Remove masking tape. 10. Firmly seat gear and timing wheel against crankshaft flange using a driver. CAUTION: Oil fumes or oil can ignite above 193 ° C (380 ° F).

Do not allow a heating element to be in direct contact with the oil. Heat the oil in a well-ventilated area. Plan a safe handling procedure to avoid burns. No clearance is allowed between gear, timing wheel, and crankshaft after gear cools. RG,RG34710,171 –19–30SEP97–1/1 CTM100 (06APR04) 02-040-26 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=222