Delphi — Thrust Bearing New Part Specifications

Thrust Bearing New Part Specifications IMPORTANT: Install thrust bearing in cylinder block and tighten to specification before regrinding or polishing thrust surfaces to ensure that all surfaces on bearing and on block web are correctly aligned. Specification Thrust Bearing New Part Specifications—Thrust Washer Clearance Base Circle (A) 162.24—163.76 mm (6.387—6.447 in.) ......................................... Thrust Surface Width (B) 42.05—42.12 mm (1.656—1.658 in.) ...................... Relief Angle (C) 45 ° ..................................................................................... Bearing Cap Overall Width (D) 43.46 mm (1.711 in.) ................................

Thrust Surface Maximum Runout 0.025 mm (0.0010 in.) .......................... A—Thrust Washer Clearance Base Circle B—Thrust Surface Width C—Relief Angle D—Bearing Cap Overall Width RG5269 –UN–20NOV97 Thrust Bearing Clearance CTM100 (06APR04) 02-040-27 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,174 –19–13AUG99–1/1 040604 PN=223 Crankshaft, Main Bearings, and Flywheel Inspect Thrust Bearings Check thrust surfaces of the thrust bearing and the thrust bearing journal on crankshaft and replace as necessary. Thrust bearings are available in each of the previously mentioned insert undersizes.

An oversize thrust washer set containing one regular size washer and two 0.18 mm (0.007 in.) oversize washers is also available. –UN–11DEC97 Specification Oversize Thrust Washers Available—Thickness................................................. 0.18 mm (0.007 in.) NOTE: Thrust bearing must be installed with slots facing RGR24545 crankshaft flange. Two halves (A) and (C) go on cap side, not block. Thrust Bearing Assembly A—Lower Rear Thrust Washer B—Upper Rear Thrust Washer C—Lower Front Thrust Washer D—Main Bearing Block Thrust Bearing E—Main Bearing Cap Thrust Bearing F—Large Tang G—Small Tang RG,RG34710,173 –19–13AUG99–1/1 02 040 27