Crankshaft, Main Bearings, and Flywheel Install Main Bearing Inserts in Block IMPORTANT: If new main or thrust bearing inserts or thrust washers are installed, they must be installed as a matched set. 02 040 28 During assembly, apply a liberal coating of clean engine oil to: RGR24545N –UN–19NOV97 All main bearing webs in block Both sides of main bearing inserts, thrust bearing inserts, and thrust washers Entire OD of crankshaft main bearing journals 1. Install six main bearing inserts in block except No. 5 thrust bearing insert. Be sure locating tabs on inserts are properly positioned with slot in block web.
Thrust Bearing Assembly A—Lower Rear Thrust Washer B—Upper Rear Thrust Washer C—Lower Front Thrust Washer D—Main Bearing Block Thrust Bearing E—Main Bearing Cap Thrust Bearing F—Large Tang G—Small Tang IMPORTANT: Thrust washers (A) and (C) go on both sides of block web only, with the slots facing the crankshaft. 2. Install No. 5 main thrust bearing insert (D) in block. Install upper thrust washer on bearing insert at rear of block web. Be sure tangs on washer are properly positioned on thrust bearing insert. 3. Check to make sure that oil holes in main bearing web are properly aligned with oil holes in bearing inserts.
RG,RG34710,175 –19–30SEP97–1/1 CTM100 (06APR04) 02-040-28 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=224