CTM100 (06APR04) 02-040-29 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=225 Crankshaft, Main Bearings, and Flywheel Install Crankshaft –UN–05DEC97 –UN–20NOV97 RG8128A RG8125B Installing Main Bearing Assembly Seating Main Bearing Cap A—JDG996 Main Bearing Cap B—D01300AA Slide Hammer Puller/Installer D01300AA Slide Hammer (B). Make sure bearing CAUTION: Crankshaft is heavy. Plan a tabs also match up before tightening cap screws. proper lifting procedure to avoid injuries. NOTE: Main bearing caps may also be installed by NOTE: If crankshaft is being replaced, vibration evenly tightening both main bearing cap damper should be replaced also. screws. 1.
Carefully position crankshaft onto main bearing IMPORTANT: Do not use pneumatic wrench to inserts using a host and lift sling. install main bearing cap screws, as damage may occur to threads. 2. Dip all main bearing cap screws in clean engine oil. Apply a liberal amount of oil to bearing inserts in 4. Before tightening cap screws on main bearing caps, caps. align upper and lower thrust flanges on main thrust bearings. Using a soft-face hammer, tap crankshaft NOTE: Make sure main bearing caps are installed on to the rear and then to the front to line up thrust the bearing bosses from which they were bearing flanges. removed.
The numbers stamped on the caps should be on the same side as the numbers 5. Tighten No. 1, 2, 3, 4, 6, and 7 main bearing cap on the block. Arrow on cap must point towards screws to the following specification. front of the engine. If bearing caps have been rebored, make sure bearing caps have Specification numbers stamped on them. Crankshaft Main Bearing Cap Screws—Initial Torque.............................................. 68 N•m (50 lb-ft) 3. Install each bearing cap and bearings with the recesses and tabs aligned in matching order using Hand-tighten No. 5 main thrust bearing cap screws.
JDG996 Main Bearing Cap Puller/Installer (A) and Continued on next page RG,RG34710,176 –19–05SEP02–1/3 02 040 29