Delphi — Install Crankshaft Rear Oil Seal Housing

Crankshaft, Main Bearings, and Flywheel Install Crankshaft Rear Oil Seal Housing NOTE: Clean all gasket material and sealant from oil pan gasket rail prior to installing rear seal housing for proper housing alignment. 02 040 32 Ensure that OD of crankshaft flange and ID of rear seal housing is free of nicks and burrs. Restore damaged surfaces with emery cloth and clean surfaces thoroughly. RG8162 –UN–05DEC97 1. Install JDG977 Pan Rail Aligner (A) onto rear pan rail (as shown) using two cap screws provided. Tighten cap screws securely. Rear Seal Housing Installed on Aligner 2.

Install rear seal housing (B) using a new gasket; bottom edge of gasket should extend through opening in alignment plate. Tighten housing cap screws finger tight. 3. Install larger end of JDG975 Timing Gear Cover/Rear Seal Housing Aligner (C) onto crankshaft rear flange with tapered locators (D) at 3 o’clock and 9 o’clock position. RG8163 –UN–05DEC97 4. Center housing and tighten cap screws to specifications using torque sequence shown in lower illustration. Centering Rear Seal Housing with JDG975 Specification Rear Oil Seal Housing Cap Screws—Torque 25 (18 lb-ft) .............................................................. 5.

Remove alignment tools from engine and trim rear seal housing gasket flush with bottom of seal housing and oil pan gasket surface. A—JDG977 Front/Rear Pan Rail Aligner B—Rear Seal Housing C—JDG975 Timing Gear Cover/Rear Seal Housing Aligner D—Tapered Locators RG8816 –UN–20MAY98 Rear Seal Housing Torque Sequence RG,RG34710,177 –19–13AUG99–1/1 CTM100 (06APR04) 02-040-32 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=228