Delphi — Install Crankshaft Rear Oil Seal and Wear Sleeve Assembly

CTM100 (06APR04) 02-040-33 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=229 Crankshaft, Main Bearings, and Flywheel Install Crankshaft Rear Oil Seal and Wear Sleeve Assembly 1. Thoroughly clean ID of rear seal housing and OD of crankshaft flange. Dry with a clean shop towel. –UN–05DEC97 2. Center JDG974A Forcing Screw (A) rear face of crankshaft and tighten cap screws securely. 3. Apply a light coat of LOCTITE 680 (TY15969) RG8164 Retaining Compound around OD of rear crankshaft flange. JDG974-2 Forcing Screw Installed 4. Position rear seal assembly (B) and JDG974A Seal Installer (C) onto rear crankshaft flange and forcing screw. NOTE:

Align mounting holes in seal casing with holes in rear seal housing as seal assembly is installed. –UN–05DEC97 5. Lubricate forcing screw threads and both sides of friction washer. Install washer and nut; tighten nut until installer bottoms. RG8165 6. Remove seal installation tool set and clean any sealant from tool. Installing Rear Crankshaft Oil Seal 7. Center seal casing and tighten cap screws to specifications following sequence in lower illustration. Specification Rear Oil Seal-to-Housing Cap Screws—Torque..............................................................

15 N•m (11 lb-ft) A—JDG974A Forcing Screw B—Rear Seal Assembly C—JDG974A Seal Installer –UN–20MAY98 RG8810 Rear Seal Torque Sequence LOCTITE is a registered trademark of Loctite Corp. RG,RG34710,178 –19–13AUG99–1/1 02 040 33