Delphi — Install Timing Gear Cover

Crankshaft, Main Bearings, and Flywheel Install Timing Gear Cover NOTE: New service timing gear covers and camshaft gear access covers have pressed-in-place gasket grooves. These covers use silicon rubber gaskets. DO NOT apply any sealant to rubber gaskets. Fel-Pro gaskets are still available for service on older covers without gasket grooves. 02 040 34 RG8788 –UN–10DEC97 1. Clean timing gear cover gasket mating surfaces. 2. Clean all gasket material and sealant (if applied) from oil pan gasket rail. JDG977 Pan Rail Aligner Installed 3. Install JDG977 Pan Rail Aligner (A) onto front pan rail (as shown) using cap screws provided. Tighten cap screws securely. NOTE:

If necessary, guide pins may be used to ensure correct gasket (B, earlier engines) and timing gear cover (C) alignment with mounting holes. IMPORTANT: On earlier engines where sealant was applied, clean front plate and timing gear cover surfaces with TY16285 Clean and Cure Primer prior to assembly. Follow instructions on label. RG8786 –UN–10DEC97 4. On earlier engines with Fel-Pro gaskets only , soak both sides of new timing gear cover gasket with LOCTITE 242 Thread Lock and Sealant and let dry for 15 minutes or until dry to the touch. Apply a 3 mm (1/8 in.) wide bead of LOCTITE 515 Flexible Sealant to timing gear cover side of gasket.

Timing Gear Cover Cap Screw Locations A—JDG977 Pan Rail Aligner B—Gasket (Fel-Pro Gasket Shown) C—Timing Gear Cover D—M10 x 55 mm (2.17 in.)—6 Used E—M10 x 65 mm (2.56 in.)—2 Used F—M10 x 110 mm (4.33 in.)—2 Used 5. Carefully install gasket on timing gear cover. On later engines with press-in-place silicon rubber gaskets, ensure gasket is properly seated in grooves of timing gear cover. 6. Install timing gear cover and wipe off excess sealant, if used. CTM100 (06APR04) 02-040-34 P OWER T ECH 10.5 L & 12.5 L Diesel Engines LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,179 –19–05SEP02–1/6 040604 PN=230