CTM100 (06APR04) 02-040-35 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=231 Crankshaft, Main Bearings, and Flywheel 7. Install cap screws (D), (E) and (F) at respective locations shown. Tighten cap screws finger tight only so that cover can be correctly centered. RG,RG34710,179 –19–05SEP02–2/6 02 040 35 8. Install, smaller end of JDG975 Timing Gear Cover/Rear Seal Housing Aligner (A) onto front crankshaft flange with tapered locators (B) at 3 o’clock and 9 o’clock position. NOTE: Earlier engines with Fel-Pro gaskets using sealant require an initial torque and a final torque –UN–11DEC97 sequence. Later engines with press-in-place gaskets require only a final torque. 9.
Center cover with crankshaft flange and initially tighten RG8790 cap screws (on earlier engines) to specifications, following sequence in lower illustration. Tighten two Aligning Timing Gear Cover longest cap screws located next to crankshaft center line. Then, go to bottom cap screws (alternating from side-to-side) and tighten remaining cap screws to specifications. Specification Timing Gear Cover Cap Screws (Early Engines Only)1—Initial Torque............................................................................. 45 N•m (33 lb-ft) Tighten timing gear cover cap screws following sequence in lower illustration to the following specification.
Specification Timing Gear Cover Cap Screws—Final Torque..................................................... 63 N•m (46 lb-ft) 10. Remove alignment tools from engine. –UN–20MAY98 A—Seal Housing Aligner B—Tapered Locators RG8812 Timing Gear Cover Torque Sequence 1 Initial torque is required only on early timing gear covers using Fel-Pro gaskets with sealant. Continued on next page RG,RG34710,179 –19–05SEP02–3/6