Delphi — Install Timing Gear Cover

Crankshaft, Main Bearings, and Flywheel NOTE: If fixed fan drive assembly (cast into camshaft gear access cover) was removed, it must be reinstalled before installing access cover. In this case, be sure cap screw (F) is installed in cover before pressing on fan hub/pulley. (See REPLACE BEARINGS IN FAN DRIVE ASSEMBLY in Group 070.) 02 040 36 IMPORTANT: On earlier engines where sealant was applied, clean timing gear cover and camshaft gear access cover gasket surfaces with TY16285 Clean and Cure Primer prior to assembly. Follow directions on label. 11.

On earlier engines with Fel-Pro gaskets only , soak both sides of new camshaft gear access cover gasket (A) with LOCTITE 242 Thread Lock and Sealant and let dry for 15 minutes or until dry to the touch. RG10268 –UN–05NOV99 Apply a 3 mm (1/8 in.) wide bead of LOCTITE 515 Flexible Sealant to timing gear cover side of gasket. Installing Camshaft Gear Access Cover A—Gasket B—M10 x 110 mm C—A/C Compressor Bracket D—M10 x 130 mm (w/Compressor Bracket) M10 x 110 mm (w/o Compressor Bracket) E—M10 x 30 mm (005482— ) M10 x 100 mm ( —005481) F—M10 x 100 mm (005482— ) M120 x 30 mm ( —005481) G—M10 x 100 mm H—Flange Nut I—M10 x 100 mm (005482— ) M10 x 30 mm ( —005481) J—Camshaft Gear Access Cover 12.

Carefully install gasket on timing gear cover mounting surface. On later engines with press-in-place silicon rubber gaskets, ensure gasket is properly seated in grooves of timing gear cover. 13. Install camshaft gear access cover and wipe off excess sealant, if used. LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,179 –19–05SEP02–4/6 CTM100 (06APR04) 02-040-36 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=232