CTM100 (06APR04) 02-040-37 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=233 Crankshaft, Main Bearings, and Flywheel 14. Install cap screws (B), (D—G) and (I), and nut (H) in respective locations. NOTE: Earlier engines with Fel-Pro gaskets using sealant require an initial torque and a final torque sequence. Later engines with press-in-place gaskets require only a final torque. 15. Initially tighten cap screws (and stud nut) to specification, following sequence in lower drawing. Specification Camshaft Gear Access Cover Cap Screws (Early Engines Only)1—Initial Torque......................................................
50 N•m (37 lb-ft) –UN–05NOV99 Finish tightening camshaft gear access cover cap screws (following sequence in lower drawing) to the following specification. RG10268 Specification Camshaft Gear Access Cover Installing Camshaft Gear Access Cover Cap Screws—Final Torque............................................. 68 N•m (50 lb-ft) 16. Install engine oil pan. (See INSTALL ENGINE OIL PAN in Group 060.) 17. Install crankshaft vibration damper.
(See INSTALL CRANKSHAFT VIBRATION DAMPER AND FRONT OIL SEAL next in this group.) A—Gasket B—M10 x 110 mm C—A/C Compressor Bracket D—M10 x 130 mm (w/Compressor Bracket) M10 x 110 mm (w/o Compressor Bracket) E—M10 x 30 mm (005482— ) M10 x 100 mm ( —005481) F—M10 x 100 mm (005482— ) M120 x 30 mm ( —005481) –UN–20MAY98 G—M10 x 100 mm H—Flange Nut I—M10 x 100 mm (005482— ) M10 x 30 mm ( —005481) RG8811 J—Camshaft Gear Access Cover Camshaft Gear Cover Torque Sequence 1 Initial torque is required only on early timing gear covers using Fel-Pro gaskets with sealant. Continued on next page RG,RG34710,179 –19–05SEP02–5/6 02 040 37