CTM100 (06APR04) 02-040-41 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=237 Crankshaft, Main Bearings, and Flywheel Install Vibration Damper on Engine 1. Install JDG973-1 Damper Remover/Installer Hub (A) onto front face of crankshaft using two cap screws provided with kit. Tighten cap screws securely. 2. Lubricate forcing screw threads with all purpose –UN–09DEC97 grease. 3. Position vibration damper and seal (B) on forcing screw hub as shown. RG8425 4. Install JDG973-2 Cross Block (C) onto forcing screw. Installing JDG973-1 Hub Secure cross block with two cap screws finger tight. NOTE:
Lubricate forcing screw and both sides of friction washer with multi-purpose grease prior to each use. 5. Install friction washer and nut against cross block. –UN–09DEC97 NOTE: Cut-outs in seal casing should be at 3 o’clock and 9 o’clock position for timing gear cover cap screw clearance. Align holes in casing with cap screw RG8426 holes as damper and seal are installed. Installing Vibration Damper 6. Tighten nut until damper bottoms on crankshaft flange. Remove JDG973 tool set from engine. A—JDG973-1 Damper Remover/Installer Hub B—Vibration Damper And Seal C—JDG973-2 Cross Block Continued on next page RG,RG34710,180 –19–13AUG99–3/4 02 040 41