Camshaft and Timing Gear Train Check and Adjust Camshaft-to-Crankshaft Timing Check Camshaft-to-Crankshaft Timing 02 050 1. Remove rocker arm cover. See (REMOVE AND INSTALL ROCKER ARM COVER in Group 020.) 2 2. Remove plug from cylinder block and install JDG820 Flywheel Turning Tool (B). IMPORTANT: JDG971 Timing Pin MUST BE installed into camshaft timing slot (A) first before attempting to install second timing pin into crankshaft timing slot (C). 3. Rotate engine flywheel in running direction (counterclockwise as viewed from rear) until JDG971 Timing Pin (A) engages single timing slot (D) in camshaft.
The proper timing slot can be found by viewing camshaft timing lobe through camshaft timing pin bore while rotating engine. The double timing slot (E) will be at approximately 11 o’clock (viewed from rear of engine) when pin is installed in slot (D). This ensures that engine is locked at TDC of No. 1 cylinder’s compression stoke. Intake and exhaust rocker arms on No. 1 cylinder should be loose. RG8228A –UN–05DEC97 JDG971 Timing Pin in Camshaft 4. Remove threaded plug from crankshaft timing hole below oil cooler and filter housing assembly.
RG8227D –UN–05DEC97 A—JDG971 Timing Pin B—JDG820 Flywheel Turning Tool C—JDG971 Timing Pin D—Single Timing Slot E—Double Timing Slot JDG971 Timing Pin in Crankshaft RG11165 –UN–30OCT00 Camshaft Timing Slot CTM100 (06APR04) 02-050-2 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,189 –19–13AUG99–1/3 040604 PN=242