Delphi — Check and Adjust Camshaft-to-Crankshaft Timing

Adjust Camshaft-to-Crankshaft Timing 1. Leave JDG971 Timing Pin in camshaft timing slot and remove camshaft gear access cover (shown removed) from timing gear cover. (See REMOVE TIMING GEAR COVER in Group 040.) RG8251C –UN–06DEC97 2. Loosen camshaft gear retainer cap screws (A). 3. Rotate crankshaft with JDG820 Flywheel Turning Tool (B) and install second JDG971 Timing Pin (C) in crankshaft timing slot. Camshaft Gear Retainer Cap Screws 4. Adjust gear train backlash and complete final assembly. (See ADJUST FRONT TIMING GEAR BACKLASH, next in this group.) 5. Tighten camshaft gear retainer plate to following torque:

Specification Camshaft Gear Retainer Plate-to-Camshaft—Initial Torque 100 (74 lb-ft) ................................. Second Torque 150 (110 lb-ft) ............................................................ Final Retorque 150 (110 lb-ft) ............................................................. RG8227D –UN–05DEC97 JDG971 Timing Pin in Crankshaft A—Camshaft Gear Retainer Cap Screws B—JDG820 Flywheel Turning Tool C—JDG971 Timing Pin CTM100 (06APR04) 02-050-3 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,189 –19–13AUG99–3/3 040604 PN=243 Camshaft and Timing Gear Train IMPORTANT:

DO NOT insert timing pin full depth into cylinder block crankshaft timing hole when rotating engine flywheel until double slot on camshaft timing lobe is at approximately 11 o’clock (viewed from rear of engine) to avoid crankshaft counterweight bending timing pin. 5. Slightly move engine flywheel back and forth with turning tool until a second JDG971 Timing Pin (C) can be installed in slot in crankshaft. This ensures that camshaft and crankshaft are in sync (properly timed). If timing pin does not enter crankshaft timing slot, crankshaft MUST BE timed to camshaft as detailed next in this group. RG,RG34710,189 –19–13AUG99–2/3 02 050 3