Camshaft and Timing Gear Train Adjust Front Timing Gear Backlash 1. Remove camshaft gear access cover from timing gear cover. (See REMOVE TIMING GEAR COVER in Group 040.) 02 050 4 2. Remove rocker arm cover from cylinder head. (See REMOVE AND INSTALL ROCKER ARM COVER in Group 020.) IMPORTANT: Rocker arm assembly should be completely installed before adjusting timing gear backlash. 3. Lock camshaft at No. 1 TDC compression stroke by rotating engine with JDG820 Flywheel Turning Tool (B) until JDG971 Timing Pin (A) fully engages timing slot (D) in camshaft. The proper timing slot can be found by viewing camshaft timing lobe through camshaft timing pin bore while rotating engine.
The double timing slot (E) will be at approximately 11 o’clock (viewed from rear of engine) when pin is installed in slot (D). RG8228A –UN–05DEC97 JDG971 Timing Pin in Camshaft This ensures that engine is locked at TDC of No. 1 cylinder’s compression stoke. Intake and exhaust rocker arms on No. 1 cylinder should be loose. IMPORTANT: DO NOT insert timing pin full depth into cylinder block crankshaft timing hole when rotating engine flywheel until double slot on camshaft timing lobe is at approximately 11 o’clock (viewed from rear of engine) to avoid crankshaft counterweight bending timing pin. RG8227D –UN–05DEC97 4.
Remove plug and install a second JDG971 Timing Pin (C) in crankshaft timing hole on right-hand side of cylinder block. Rotate engine flywheel back and forth with JDG820 Turning Tool until timing pin (C) enters timing slot in crankshaft counterweight. JDG971 Timing Pin in Crankshaft A—JDG971 Timing Pin B—JDG820 Flywheel Turning Tool C—JDG971 Timing Pin D—Single Timing Slot E—Double Timing Slot RG11165 –UN–30OCT00 Camshaft Timing Slot CTM100 (06APR04) 02-050-4 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,190 –19–19SEP02–1/6 040604 PN=244