CTM100 (06APR04) 02-050-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=247 Camshaft and Timing Gear Train IMPORTANT: Both shims MUST BE tight between gear teeth before and after tightening idler carrier cap screws. 9. Weight of gear should seat idler gear and carrier assembly between shims (A and B) so that both shims –UN–16SEP02 are tight and cannot be removed from gear teeth. 10. Remove three idler gear carrier cap screws (C), one at a time, and apply LOCTITE 242 Thread Lock and RG12422 Sealer. Re-install and tighten to specifications. Specification Idler Gear Carrier Cap Screws Upper Idler Gear Thrust Plate Cap Screws—Initial Torque.............................................
35 N•m (26 lb-ft) A—0.13 mm (0.005 in.) Shim B—0.25 mm (0.010 in.) Shim C—Cap Screws Both shims MUST BE tight between gear teeth. 11. Retorque idler gear carrier cap screws to specifications. Specification Upper Idler Gear Thrust Plate Cap Screws—Final Torque............................................. 35 N•m (26 lb-ft) LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,190 –19–19SEP02–5/6 02 050 7