Camshaft and Timing Gear Train 12. Remove six camshaft retainer cap screws, one and a time in sequence shown, and apply LOCTITE 242 Thread Lock and Sealer. Re-install and tighten to specification. 02 050 Specification Camshaft Gear Retainer Plate-to-Camshaft—Initial Torque 100 (74 lb-ft) ................................. 8 13. Next, retorque cap screws to the following specification in sequence shown. Specification Camshaft Gear Retainer Plate-to-Camshaft—Second Torque 150 (110 lb-ft) ......................................................................... RG8813 –UN–20MAY98 14. Finally, retorque cap screws to the following specification in sequence shown.
Specification Camshaft Gear Retainer Plate-to-Camshaft—Final Retorque 150 (110 lb-ft) ...................................................................... Camshaft Gear Retainer Torque Sequence 15. Remove two lower idler gear thrust plate cap screws and backlash template and rotate engine flywheel to remove shims. Apply LOCTITE 242 Thread Lock and Sealer to two cap screws. Re-install and tighten to specifications. Specification Upper Idler Gear Thrust Plate Cap Screws—Final Torque 35 (26 lb-ft) ............................................. LOCTITE is a registered trademark of Loctite Corp.
RG,RG34710,190 –19–19SEP02–6/6 CTM100 (06APR04) 02-050-8 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=248