Delphi — Replace Camshaft Bushings

Camshaft and Timing Gear Train 10. Remove tool set and insert the smaller end of JDG968-5 Alignment Pin from the TOP side of tower oil lube hole. This pin must pass through installed bushing completely to ensure proper lube hole alignment. 02 050 24 If alignment pin does not pass through bushing oil hole, remove bushing and install a new one. RG8338 –UN–21MAY98 Install remaining bushings using the same procedure as above and by positioning tool set as follows: IMPORTANT: Protect previously installed bushings from tool damage with clean shop towels when installing 313793 Forcing Screw through bores. Checking Bushing Oil Hole Alignment 11. No. 2 Bushing:

Install JDG968-2 Bushing Installer and JDG968-4 Alignment Sleeve with bushing in front of tower No. 3 and JDG968-3 Guide in rear of tower No. 5. RG8339 –UN–21MAY98 12. Install 313793 Forcing Screw with double nut toward front of engine. 13. Use a 304.8 mm (12.0 in.) extension with ratchet to reach double nut. Index Pin Installed through Bushing 14. No. 4 Bushing: NOTE: Install bushing No. 4 before installing bushing No. 3. Adjust double nut position on forcing screw so that double nut is 51 mm (2.0 in.) from end of rod. NOTE: JDG968-1 Bushing Remover can be positioned in tower No. 6 as a pilot, if desired. 15.

JDG968-2 Bushing Installer and JDG968-4 Alignment Sleeve with bushing in front of tower No. 7 and JDG968-3 Guide in rear of No. 5 tower without bushing. 16. Install 313793 Forcing Screw with double nut and thrust washer against JDG968-3 Guide [51 mm (2.0 in.) with forcing screw extending through guide]. CTM100 (06APR04) 02-050-24 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,196 –19–25OCT00–6/7 040604 PN=264